Adjustable Elastic Headband With Interchangeable Shabby Flowers

Today, I am making a Adjustable Elastic Headband with Interchangeable Shabby Flowers.  It is super easy to do and adorable on both babies and big 😉 kids alike.

Supplies for Adjustable Headband:

  • 1 set of headband ring and slider
  • 24″ length of 5/8″ Elastic for headbands
  • Glue of your choice: Fabric Tac or Hot Glue
  • Lighter or Chef’s Torch

Supplies for Shabby Flower Embellishment:

  • 2″ Shabby Flowers of your choosing
  • 1/2″ x 1″ square of Coordinating Felt
  • 1 1/2″ Circles of Coordinating Felt
  • Glue of your choice: Fabric Tac or Hot Glue
  • Coordinating Size 20 KAM Snaps

Adjustable Elastic Headband:

Adjustable Headband with Shabby Flowers pic1

Adjustable Headband with Shabby Flowers pic2

Adjustable Headband with Shabby Flowers pic3

Instructions:

1.  Cut your Elastic to 24″ length and heat seal the ends with the Lighter.  Be careful to just seal the ends, not start them on fire :).  (You may want to practice on a scrap piece if this is your first time.)

Adjustable Headband with Shabby Flowers pic4

Adjustable Headband with Shabby Flowers pic5

Adjustable Headband with Shabby Flowers pic6

2.  Take your 24″ length of Elastic and feed the decorative/shiny side of the Elastic up through the first loop in the Slider over the bar and back down through the second loop in the Slider.

Adjustable Headband with Shabby Flowers pic7

Adjustable Headband with Shabby Flowers pic8

Adjustable Headband with Shabby Flowers pic9

3.  Pull the Elastic until it is about 3/4″ sticking out the bottom of the second loop of the Slider.

4.  Flip the Slider over so that the wrong sides of the Elastic is face up, this is the bottom of the Slider.  Put a dab of glue on the Elastic and press the 3/4″ of Elastic to it firmly.  Wiping away any excess glue.

Adjustable Headband with Shabby Flowers pic10

Adjustable Headband with Shabby Flowers pic11

5.  From the opposite side, slide the single Slider Loop about half way on to the Elastic.

6.  You now have the single Slider Loop in the center of your elastic and the slider attached to one end.
Adjustable Headband with Shabby Flowers pic12
Adjustable Headband with Shabby Flowers pic13
7.  Take the other end of Elastic decorative side up and feed it through the double Loop Slider the same way as before.  Up through the first Loop over the bar and down through the second Loop.
Adjustable Headband with Shabby Flowers pic14
8.  Now pull the elastic through the Slider until you reach the single Slider.
Adjustable Headband with Shabby Flowers pic15
Adjustable Headband with Shabby Flowers pic16
Adjustable Headband with Shabby Flowers pic17
9.  Feed the end of your Elastic through the single ring and overlap it about 3/4″ and glue down.
Adjustable Headband with Shabby Flowers pic18
Adjustable Headband with Shabby Flowers pic19
Adjustable Headband with Shabby Flowers pic 20

10.  You now have an adjustable headband.  Tada!  But wait there is more ;)!

Interchangeable Shabby Flower Embellishments:

Add the Shabby Flower pic1

Add the Shabby Flower pic2

Add the Shabby Flower pic3

Add the Shabby Flower pic4

Add the Shabby Flower pic5

Add the Shabby Flower pic6

Instructions:

1.  Glue the 1 1/2″ circle of Felt to each of the Shabby Flowers.

Add the Shabby Flower pic7

Add the Shabby Flower pic8

Add the Shabby Flower pic9

2.  Once it has had some time to dry, install a Size 20 KAM Snap Cap and stud in the center of each Shabby Flower.  The stud should be facing down on the underside of the Shabby Flower in the Felt.  Repeat for each flower. (In the pictures, I used Size 16 but found that it did not hold well and had to replace them with Size 20.)

Add the Shabby Flower pic10

3.  Glue the 1/2″x1″ square of Felt to the underside of the Elastic where you want to locate the Shabby Flower.

Add the Shabby Flower pic11

4.  Once it has had some time to dry, install a KAM Snap Cap and socket through it.  The socket facing up on decorative side of the Elastic.

Add the Shabby Flower pic13

Add the Shabby Flower pic12

5.  Snap the flower in place and go!  Tada!

© ILikeBigButtons.com and I Like Big Buttons Blog, 2016.

Save

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s