I Like Big Buttons! – How To Make A Fabric Cover Button Mini Clothespin

Today, I made an adorable office or home accent: Fabric Cover Button Mini Clothespins. I am absolutely in love with their bright colors and tininess!

Supplies:

  • 1 Completed Flat Back Fabric Cover Button (Attach size 20 (1/2″ / 12 mm), size 24 (5/8″ / 15 mm), or size 30 (3/4″ / 19 mm) flat back cover buttons.)
  • 1x Mini Wooden Clothespin (Approximately 1 3/8″ x 1/4″ in size)
  • 1x Small Plain Button
  • E6000, Hot Glue, or comparable adhesive

I Like Big Buttons! – How To Make Fabric Cover Button Mini Clothespins Video

I Like Big Buttons! – Picture Tutorial Below:

1.  Cut your fabric scrap. You will want a circle that is about twice the diameter of your button blank.

2.  Put your fabric piece in the larger assembly tool piece (RIGHT SIDE DOWN). When you look into the tool you want to see the back of the fabric.

3.  Place the button front (the domed piece) on top of the fabric. Leave the fabric edges hanging out.

4.  Press the cover button edges down into the tool. *TIP* To make it easier on my fingers, I use a sharpie marker to apply pressure.

5.  Place the back cover button piece on top of your fabric and button front. *TIP* If the cover button will be subject to repeated tugging from the back, you may want to add a little e6000 adhesive before attaching the back.

6.  Take the smaller piece of the assembly tool and with the open side down place it on the button back.

7.  Press down. You may hear a pop when the last bit of the button back slips into place. If you take the tool out and the button is not completely secured, just put it back in and press down again. *TIP* I often use a flat piece of wood to apply pressure, again to save my fingers. It also helps to avoid the button back going in at an angle.

8.  When you take the small assembly tool piece off, the fabric edges will be secured underneath the button back.

9.  Remove the button from the larger assembly tool piece.

10.  Tada! Now to attach it to the Clothespin.

11.  Use Hot Glue or E6000 to adhere a small plain button to the underside of the Cover Button. This is to fill the space between the back and the edges. You can also use felt or some other small object. You just need it to be sturdy enough to offer support. A small plastic button works great for this. You will see that the button is now flush across the bottom. I cut off the little nubs of glue that leaked through the button holes.

12.  Now adhere the finished Cover Button to the Clothespin. Press into place and center it until you are pleased with the alignment. Set aside to dry.

13. Tada! Additional uses:

  • Add a thin magnet to the back and use on your magnetic board.
  • Add a push pin to the back and use on your cork board.

To see other great Fabric Cover Button ideas, visit our DIY Project section here.

© ILikeBigButtons.com and I Like Big Buttons Blog, 2017.

Save

Save

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s